Soldering enamel wire might be tricky for some people, but it can also be a ton of fun! If you do not do it correctly, your wire may not work at all and that is certainly not good! We will learn the proper steps to solder enamel wire through this guide. Performing these steps thoroughly will ensure your wire is successful!
They are usually a soft thin wire that is coated with enamel on the outer side. This enamel layer is there to prevent the wire from getting damaged. Basically, when you pull the spot off, it will expose the metal inside (the wires were painted). Drilling is important because soldering is actually melting something called solder metal onto the wire so that it can connect to something. The solder won’t stick properly if there is still enamel on the wire, and therefore your connection won’t work.
Now use the sandpaper to sand the end of the wire where you wanna solder. This process is significant because it strips the enamel from that spot. The solder will not adhere without the enamel being stripped away and your connection is going to be weak.
Now you can prepare to fire up that soldering iron. You can’t just jump into soldering, you need to warm it up. This is a crucial step as you want the iron to get hot enough to melt the solder when the iron touches the wire.
The solder comes next, once your soldering iron is warm. Use the soldering iron to add a little solder to its tip. Then, placing the tip of the iron carefully, touch it to the area of the wire where you wish to make your connection. The solder will melt with it due to the heat in the iron, and the solder will flow on to the wire and connect it to whatever you are attaching it to.
The next step is to remove the soldering iron after few seconds. The solder has a fast cooling down and solidification that will ensure a robust joint between the wire and the object you are soldering to.
Applying Excessive Quantity of Solder: Using an excessive quantity of solder can create an untidy appearance and look bad. It also makes it more troublesome to repair things later down the line if you have to take the wire out.
Copyright © Yichun Shenyue Electrical Technology Co., Ltd Todos os direitos reservados
EN
